Public Fields

	Name	Description
	BiPotCR	Specifies the current range for WE2.
	BiPotPotential	Specifies the potential for WE2.
	CellOnAfterMeasurement	Enable/disable cell after measurement
	ConcentrationUnit	The label for the unit of the analyte's concentration. This value is not used for calculations.
	ConditioningPotential	Conditioning Potential
	ConditioningTime	Conditioning Duration
	DepositionPotential	Deposition Potential
	DepositionTime	Deposition Duration
	EquilibrationTime	Duration
	MinPeakHeight	Determines the minimum peak height. Peaks lower than this value are neglected.
	MinPeakWidth	Determines the minimum peak width. Peaks width a lower width may not be detected.
	MuxMethod	Defines the way the multiplexer is used. 0 = measure channels sequentially 1 = measure channels alternatingly
	PeakOverlap	Is used when two peaks are very close to each other. If the peak separation is less than the specified value, a single baseline is used for the two overlapping peaks. If each peak should have its own baseline, specify a value of 0.
	PeakWindow	Is used to identify which component corresponds to which peak. Peaks must be within the peak window.
	Ranging	Ranging information
	RecordAux	Auxiliary channel to record
	Sample	Description of the measured sample.
	Sensor	Description of the sensor used.
	SmoothLevel	The smoothlevel to be used. 0 = no smooth 1 = 5 points 2 = 9 points 3 = 15 points 4 = 24 points
	StandbyPotential	Stand by Potential
	UseMuxChannel	Specifies channels used for this method.
	UseStirrer	True if a stirrer is being used.
	ViewBottom	The lowest value on the Y axis of the plot.
	ViewLeft	The lowest value on the X axis of the plot.
	ViewRight	The highest value on the X axis of the plot.
	ViewTop	The highest value on the Y axis of the plot.
	XUnit	Unit for X axis when using this method.
	YUnit	Default unit for Y axis when using this method.

Top

Public Fields

See Also